The beauty of this mod is that if you take the iPod dock out later on, placing the inner ashtray back in. What you need to do here is "simply" cut a rectangle out of the front part of the ashtray.ġ) Remove the Inner Ashtray piece and store it some place for when you finally sell your car / trade her back in. (NOTE: I removed and replaced the ashtray without taking the radio out again, but I swore and drew a little blood - nothing broke however) If you aren't able to remove the radio & climate control, be careful not to scratch anything, and.good luck. If you have the radio tools take the radio out! This was my temporary setup:Ī4-Freddy posted a break down of the Ashtray.ġ) Pull the leather shift boot away from the trim as indicated in the pic belowĢ) Repeat on the opposite side and pull shift boot up out of the way.ģ) The trim piece is clipped at all four corners - simply place your hands under the trim piece and pull directly up at each corner until it comes un-clipped.Ĥ) Slide the trim piece up and over the shifter and put aside.ĥ) Remove the insulating foam (shaped like a U) from around the shifter linkageĦ) Un-bolt the two bolts holding the ashtray in.Īt this point if you are doing this at the same time the radio is out, things will be simple. This step can be completed before you are ready to do the ashtray mod. Yeahboz posted by far the best Blitzsafe adapter installation instructions I have seen. 9 or 10 mm socket or wrench (to remove ashtray bolts - I can't recall which right now).O (Or Hacksaw & Drill will work - did for me but I would rather use a dremel) 1/8" Mini à RCA (male) Audio Cable (~3ft).3rd Generation iPod Dock & iPod (will also work with iPod mini - note it will be a lot easier to fit the iPod mini dock).If it is tech section worthy, mods please feel free to move this there. I am not sure if this is tech section worthy, so book mark it.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |